System for Measurement of the Geometry of Brake Disks,
Torque Converters and Other Components
GS 1000

Range of application
Measurement of diameter and runout including FFT analysis on brake discs, torque converters, pulleys, shafts and clutch discs.

Depending on application, the measuring system may be integrated into a single- or multi-station vertical-axis balancing machine. If shorter cycle times are required, a separate machine should be used.

Design

• Integrated into a vertical-axis balancing machine or as a separate station
• Fully automatic sequence of operations with freely program mable controller with fault diagnosis
• Evaluation by means of PC
• Work-piece clamping and measurement of required features
• Manual loading of machine, optionally with handling and conveyor equipment

Runout measurement on gearbox components integrated in a fully automatic vertical balancing machine. Runout is measured during the unbalance measurement run. If unbalance and runout are within tolerance, the work-piece is deposited on the „Within Tolerance“ conveyor.

This system determines the characteristics of a brake disc. The machine works fully automatically and is loaded by means of a handling system. Characteristics measured include: - Lateral and radial runout - Waviness - Diameter - FFT analysis - Inclusion of temperature coefficient

Measurements on torque converters. The geometry measuring machine is loaded and unloaded automatically. Characteristics determined include: - Lateral runout and roundness of arbor/flange - Arbor/flange diameter - Runout of driver flange - Axial play of inner turbine (bearing play)

The torque converter is driven from the outside through a drive wheel. Characteristics are determined mechanically and optically.

The movable spindle sleeve arranged from above is used to measure the axial play of the inner turbine on the non-rotating converter.